Description

This small piece of machined and Type III Hard Anodized 6061 aluminum perfection was designed to hold a wire with a max diameter of 0.130″ (most standard switch wires are 0.110-0.125″).  As its honest name implies, it was designed to hold just 1 wire on whichever side of the Picatinny rail you choose.  This is a solid, functional piece that will serve all users well.  Installation is a breeze and you can use as many as you see fit to contain all the errant wires on your weapon.  It can be oriented to hold the wire on either side of the rail, making it simple and versatile.

*** Max torque on the clamp screw is 5 in-lbs.  If the clamp sections start to angle towards each other you have gone too far.  We recommend using a small drop of blue thread locking compound on the screw prior to installation to prevent the screw from backing out.  To remove the screw after the thread locker has set, a few seconds of heat from a lighter or small torch is all that is needed.